360mm 700w carbon fiber infrared heat lamps

Wed, 29 Jul 2026 00:46:05 +0800

Let’s talk about these 360mm 700W Carbon Fiber Lamps

If you’re dealing with heavy thermal loads and you need your heat to hit now, these lamps are your best bet. Most people are used to quartz heaters, but these are different. We use a carbon fiber filament that puts out shortwave radiation. In plain English? The heat doesn’t bother wasting time warming up the air around the part. It just goes straight into the material. The power side of things At 700W over 360mm, you’ve got a sweet spot. It’s plenty of punch to get the job done, but it won’t melt your lamp housing if you’re careful. It’s incredibly fast. But here’s the catch: your power supply needs to be rock solid. If you’ve got voltage spikes jumping around, you’ll fry that carbon filament way faster than you would with an old-school tungsten wire. Keep it steady. Why carbon fiber? Metal filaments hate it when things get hot and cold quickly—they expand, they shrink, and eventually, they snap. Carbon fiber handles that stress much better. It’s tougher. Plus, because of how the light spectrum shifts, you aren’t wasting energy heating up your conveyor belt or the frame of your machine. The heat actually goes where it belongs: the workpiece. One quick tip: if you’re dropping these into an old rig,**clean your reflectors.**A dusty or dirty reflector basically kills the efficiency of a carbon lamp. It’s not worth the waste. Getting them to work for you These are pretty easy to swap into most industrial drying or curing lines. You can get them wired up in no time. Just keep in mind that they don’t “throw” heat the same way halogen tubes do. You might find you need to tweak your PID settings or move the lamp a little closer to the target to hit your temperature goals. And a word of warning: don’t run these at 100% all day without some decent ventilation. If the heat just sits there, those end caps are going to take a beating. Give them some room to breathe.

High quality 360mm 700w carbon fiber heating element

Tue, 23 Jun 2026 11:31:58 +0800

Introduction

We built this 360mm, 700W carbon fiber heating element for one simple reason: to be a straight-up replacement for industrial machines that need heat on demand. If you’re running blow molding, extrusion, or packaging gear, you know the drill. You need heat that gets there fast, stays rock-solid, and doesn’t quit when the shift runs long. This was built for that reality.

The Power, Voltage, and Size—Straight Talk

The 700W rating hits a sweet spot. It packs enough punch in a small footprint, but it doesn’t push the element into overdrive where it starts to stress out. With a 360mm active length, you get predictable coverage across standard barrel and die zones. So you can spec a zone without having to redesign the whole machine. Just make sure the voltage lines up before you wire it in. That keeps the current in the safe zone for most control panels, and it means your heat-up behavior is consistent—every single time.

700w on IR UV Forums

360mm 700w carbon fiber infrared heat lamps

Let’s talk about these 360mm 700W Carbon Fiber Lamps

High quality 360mm 700w carbon fiber heating element

Introduction

The Power, Voltage, and Size—Straight Talk